FM Radio Tuner
Crestron
C2N-TFM
10
•
FM Radio Tuner: C2N-TFM
Operations Guide - DOC. 6233A
9. In the "Set Network ID" window, click
Close
.
NOTE:
The new Net ID code may also be verified by selecting
Diagnostic |
Report Network Devices
in the Viewport (alternately, select
F4
).
10. Repeat this procedure for each C2N-TFM to be added to the system.
Method B (Touch Settable IDs)
Before using this method, you should have a list of all current network devices and
their Net IDs, to avoid assigning duplicate IDs.
Set Net ID by TSID
These procedures are for TSID-enabled network devices during the initial
configuration of a Cresnet system or when such devices are being added/replaced.
1. Ensure that all C2N-TFMs are connected to the control system.
2. Open the Crestron Viewport version 3.35 or later.
3. From the Viewport menu, select
Functions | Assign Cresnet ID by
Serial Number
. The “Set Net ID by TSID” window appears. The
window is first displayed with the data fields empty. (Refer to the
following figure.)
“Set Net ID by TSID” Window
4. Click on the
Search for Touch Settable Devices
button. The system
searches the network and lists all TSID-enabled devices found. The list
is similar to the report produced by pressing
F4
(Report Network
Devices); the first eight digits of each line constitute the TSID number
(hexadecimal form of the serial number).
Summary of Contents for C2N-TFM
Page 1: ...Crestron C2N TFM FM Radio Tuner Operations Guide...
Page 4: ......
