2
quickstart guide
CBLR Series
www.crestron.com
888.273.7876
201.767.3400
Specifications subject to
change without notice.
CBLR Series
QUICKSTART DOC. 7245C (2032356, Sheet 1 of 2) 02.14
Cable Retractors for FlipTops™
For regulatory compliance information, refer to Doc. 7475.
NOTE: For assembly of FlipTop 600 Series models, refer to “Attach Cable Retractors to
the FlipTop (FlipTop 600 Series)” in the third column on this page.
Typical Assembly (Horizontal Orientation)
Retractor ‘A’
Retractor ‘B’
2-Wire Spacer
Blank Spacer
Clevis Pin
Hairpin
Cotter Pin
Mounting
Bracket
Assembly
Retractor ‘A’
Retractor ‘B’
2-Wire Spacer
Blank Spacer
Clevis Pin
Hairpin
Cotter Pin
Mounting Bracket
Assembly
Typical Assembly (Vertical Orientation)
2
Adjustments
Once the retractor arm configuration is set, refer to the following illustration and adjust
retractor arm tension and cable retraction speed as follows:
1. Adjust retractor tension by loosening the top thumb screw enough to enable pulling or
pushing the adjacent cable end to align the red screw with the label arrow.
2. Adjust cable retraction speed by first pulling the knob outward and moving it to the
VERT
or
HORZ
position to match the configuration of the retractor arms.
a. Pull the cable (plug end) out so it is fully extended.
b. Press the retraction lever and observe the speed of the cable retraction. If
it is too slow or too fast, reposition the knob to an intermediate position and recheck.
ONCE INSTALLED, USE TOP THUMB
SCREW TO ADJUST CABLE LENGTH UNTIL
RED SCREW IS ALLIGNED WITH ARROW
Thumb Screw
Cable End
SLOW
HORZ
CABLE RETRACTION
SPEED ADJUST
VERT
FAST
Knob
Red Screw
Retraction
Lever
Adjusting Retractor Tension and Retraction Speed
3
Assembly
Assembly consists of:
•
Attaching the cable retractors to the FlipTop box
•
Attaching the horizontal mounting bracket and
connecting the retractor arms for horizontal orientation
During the following procedures, refer to the accompanying illustrations.
Attach Cable Retractors to the FlipTop (Non-FlipTop 600 Series)
1. Insert the necks of the retractors and any included spacers up and into the mounting
bracket assembly until they engage the frame of the assembly.
2. Carefully slide the clevis pin through the hole in the side of the mounting bracket
assembly and through each item being mounted until it protrudes through the opposite
side of the assembly.
3. Insert the supplied hairpin cotter pin into the hole in the clevis pin to secure it.
4. Tighten the screws in the neck assemblies so they are just snug against the clevis pin.
(Shown in “Attach the Horizontal Mounting Bracket” on page 3.)
Attach Cable Retractors to the FlipTop (FlipTop 600 Series)
1. Insert the necks of the retractors into the FlipTop until they engage
the frame of the assembly.
2. Insert the shoulder screws in the front of the FlipTop.
3. Tighten each individual set screw on the retractors.
Shoulder Screws
Attach the Cable Retractors (FlipTop 600 Series)
