2
quickstart guide
CCS-UC-100
www.crestron.com
888.273.7876
201.767.3400
Specifications subject to
change without notice.
QUICKSTART DOC. 7479B (2035756, Sheet 1 of 2) 08.13
Crestron RL™ Group Collaboration System for Lync
®
CCS-UC-100
2
Installation
(Continued)
I. Alternate
Codec
Mounting
The following information applies only to installations in which the
codec is not to be attached to a wall plate.
Table/Shelf Mounting
.
.
Rack Mount
Bracket - One
Each Side
.
Remove Three Side Cover Screws
and Discard. Typical, Both Sides
Attach Bracket To
Unit Using Screws
Supplied
Rack Mounting
Rack Rail
Rack Mount
Screws (Not
Supplied)
.
Remove Both Side Cover Top
Screws And Discard Before
Attaching Bracket To Unit.
Typical, Both Sides
Locate unit position and mounting holes under the table/shelf using
the supplied mounting template.
Attach Bracket To
Unit Using Screws
Supplied
Screws To Mount
To Table/Shelf
(Not Supplied)
Shelf Mount
Bracket - One
Each Side
F. Attach Sound Bar to Display
1. Attach the sound bar bracket to the bottom (recommended) or top
of the display frame using the four supplied screws as shown in
the following illustrations.
2. Remove the two screws and mounting brackets from the rear of
the sound bar as supplied, and use the screws to attach the sound
bar to the sound bar bracket. (Retain the mounting brackets for
possible alternate sound bar mounting configuration.)
Bottom Mounting
Configuration
Six Camera
Mounting
Locations
D. Attach Codec to the Wall Plate
1. Hook the mounting brackets attached to the codec to the top bar
of the wall plate.
2. With the brackets resting against the bottom bar, tighten the
bracket screws so that they extend under the bottom bar to
secure the codec in position.
E. Attach Display to the Wall Plate
Attach the display to the wall plate as described in the
CCS-TS-6500-WMK Installation Guide (Doc. 7511).
WARNING
: At least two qualified people should perform the
mounting procedure. Personal injury and property damage can
result from dropping or mishandling the flat panel.
For regulatory compliance information, refer to Doc. 7548.
!!
NOTE
: If the camera is to be mounted in the top center position,
the screws already holding the touch overlay control box need to be
removed since the camera bracket uses the same screws. The
camera is then mounted on top of the control box, with one screw
going through both plates into the overlay frame.
Wall Plate
(Accessory
Bracket Assembly
Not Shown)
Tighten Bracket Screws To
Prevent Codec From Being
Accidentally Dislodged
Hook Brackets
To Top Bar
Bottom
Bar
Bracket
Screws
Sound Bar
Screw
Sound Bar
Screw
H. Attach Camera to Display
1. Insert the camera into the camera bracket for top (recommended) or
bottom mounting, and secure the camera using the single supplied
screw.
2. Use the two supplied screws to attach the camera bracket with
camera to the monitor frame in one of the three available locations
opposite the sound bar location.
Top Mounting
Configuration
Bracket Screws
Sound Bar
Screw
Sound Bar
Screw
Top Mounting
Configuration
Camera
Camera
Bracket
Camera
Bracket
Camera
Bottom Mounting
Configuration
Sound Bar
Bracket
Sound Bar
Bracket
G. Alternate Sound Bar Mounting
In certain configurations, it may be desireable to have the sound bar
mounted on a wall or on a horizontal surface rather than on the 65”
touch screen. In such cases, refer to the instructions in the Quickstart
Guide (Doc. 7560) supplied with the sound bar.