Network Video Streamer
Crestron
CEN-NVS100
Using a Web Browser
The CEN-NVS100 user interface can be accessed from the following Web browsers:
•
Internet Explorer
®
7.0 or higher
•
Firefox
®
3.0 or higher
•
Safari
®
4.0 or higher
NOTE:
Some configuration parameters require the use of the Internet Explorer
Web browser.
To access the CEN-NVS100 from a Web browser:
1. Start your Web browser.
2. Go to the IP address or host name of the CEN-NVS100.
NOTE:
If the default HTTP port number of 80 has been changed, you must
append the port number to the IP address by entering a colon followed by
the new port number. If, for example, the IP address is 192.168.10.225 and
the HTTP port number has been changed from 80 to 150, go to
http://192.168.10.225:150
.
For information about changing the HTTP port number, refer to
“Configuring Network Settings” on page 27.
3. If necessary, perform either of the following:
•
For initial access to the CEN-NVS100 using Internet Explorer, you
may be prompted for permission to install a new plug-in for the
CEN-NVS100. Click
Yes
to proceed. If Internet Explorer does not
allow you to continue installation of the plug-in, check the Internet
security option and lower the security levels or contact your IT or
networking supervisor for assistance. The plug-in must be installed to
display the video in the Web browser.
NOTE:
The Internet Explorer request to install a plug-in for the
CEN-NVS100 depends on the Internet security settings of your PC.
If the highest security level is set, the PC may prohibit any installation
and execution attempt.
•
For initial access to the CEN-NVS100 using Firefox, install the
QuickTime
®
media player.
The user name and password window opens, allowing you to log in to the
CEN-NVS100. For log-in information, refer to “Logging In to the
CEN-NVS100” on page 11.
10
•
Network Video Streamer: CEN-NVS100
Operations & Installation Guide – DOC. 6873A