Network Video Streamer
Crestron
CEN-NVS100
6. Do any or all of the following:
•
Click the
Image Settings
button to set image settings. Refer to
“Configuring Image Settings” below for information.
•
Click the
Privacy Mask
button to block one or more areas of the
video from being viewed on the video output. Refer to
“Configuring Privacy Mask Settings” on page 41 for information.
•
Configure video settings for Stream 1/Stream 2. Refer to
“Configuring Video Quality Settings” on page 42 for information.
7. Click
Save
at the bottom of the “Audio and Video” configuration page to
save changes to video settings.
Configuring Image Settings
Configure image settings by pressing the
Image Settings
button in the “Video
Settings” pane of the “Audio and Video” configuration page. The “Image Settings”
configuration page opens.
“Image Settings” Configuration Page
NOTE:
The “Image Settings” configuration page can also be accessed by entering
the following URL address in your Web browser:
http://
Video Streamer
/setup/image.html
Video Streamer
is the host name or IP address of the CEN-NVS100.
On the “Image Settings” configuration page, adjust the
Brightness, Contrast,
Saturation,
and
Hue
settings as desired for video compensation. Values in the drop-
down lists range from –5 to +5.
NOTE:
A value of 0 for
Brightness
and
Contrast
auto tunes the video.
To preview the image with change(s) before saving the change(s), click
Preview.
To recall the previous settings without saving the current settings, click
Restore.
To save the change(s), click
Save.
To close the page, click
Close.
40
•
Network Video Streamer: CEN-NVS100
Operations & Installation Guide – DOC. 6873A