Network Video Streamer
Crestron
CEN-NVS100
•
Patrol selection:
Provides a list of preset positions that corresponds to the
Preset Position:
drop-down list and allows selection of desired preset
positions to be set as patrol stops:
⇒
Preset locations:
From the list of preset positions, highlight the
desired position to be set as a patrol stop and then click
Select.
Up
to 20 preset positions can be set as patrol stops.
⇒
Selected locations:
Provides a list of preset positions selected as
patrol stops:
•
To remove a preset position from the list of patrol stops,
click
Remove.
•
To move a preset position upward in the list of patrol
stops, click
Up.
•
To move a preset position downward in the list of patrol
stop, click
Down.
To save the patrol selections, click
Save.
NOTE:
As mentioned above, you must click
Save
to save the
Dwelling time
and
Patrol selection
settings. If you do not click
Save,
the
Dwelling time
and
Patrol
selection
settings do not take effect.
Setting Custom Commands
Set custom commands by pressing the
Custom Command
button on the “Camera
Control” configuration page. The “Custom Command” configuration page opens.
NOTE:
Up to five custom commands can be set.
NOTE:
If you selected
Custom camera
as the PTZ driver on the “Camera Control”
configuration page, you must configure pan, tilt, zoom, and focus functions by
setting custom commands.
“Custom Command” Page (Not Applicable to Custom Camera)
50
•
Network Video Streamer: CEN-NVS100
Operations & Installation Guide – DOC. 6873A
