Crestron
CEN-UPS1250
Uninterruptible Power Supply
The “INPUT FREQ: XXHZ; OUTPUT FREQ: XXHZ” screen displays the actual
input utility voltage frequency as well as the actual voltage frequency being output to
the connected devices.
NOTE:
At times, the frequency values on this screen may not match. This is
because separate circuits are used to make frequency measurements and there is a
time delay between the two circuits when updating the status screen. This condition
is considered part of the normal operation of the unit.
“INPUT FREQ: XXHZ; OUTPUT FREQ: XXHZ” Screen
INPUT FREQ:60HZ
OUTPUT FREQ:60HZ
The outlet status screens shown below display which of the four outlet banks are
turned on or off. The outlet banks can be turned on or off independently using a
control system connected via the
LAN
port on the rear panel.
“BANK1 (DIGITAL): ON; BANK2 (DISPLAY): ON” Screen
BANK1 (DIGITAL):ON
BANK2 (DISPLAY):ON
“BANK3 (ANALOG):ON; BANK4 (HI AMP):ON” Screen
BANK3 (ANALOG):ON
BANK4 (HI AMP):ON
The model number and serial number screen displays information about the
CEN-UPS1250.
“MODEL #; S/N” Screen
MODEL#:CEN-UPS 1250
S/N:PB0707130791
The “ENV. TEMPERATURE” screen displays room temperature in both Celsius and
Fahrenheit when the included temperature/RH sensor is connected to the unit. The
values displayed may be rounded.
“ENV. TEMPERATURE” Screen
ENV.TEMPERATURE:
24.50C 76.0F
The “R. HUMIDITY” screen displays the relative humidity when the included
temperature/RH sensor is connected to the unit.
“R. HUMIDITY” Screen
R. HUMIDITY: NOT AVAIL
Operations & Installation Guide – DOC. 6635E
Uninterruptible Power Supply: CEN-UPS1250
•
25
