Crestron
CLW-DIM1/4RF, -DIMS1/4RF, -SLVD1RF
infiNET™
Dimmers
Operation
During operation, the device may be warm to the touch during operation. This is
normal.
Mode Selection Switch
These dimmers use a three-position mode selection switch to set the mode of
operation.
OFF
When the mode selection switch is in the “OFF” position, the pushbutton(s) will not
have any function and the load is disconnected from the power source. This
must
be
used when changing light bulbs to ensure that the load is fully disconnected from
power. Slave devices that are connected to the dimmer will not have any function
when the Master’s mode selection switch is in the “OFF” position.
RUN
When the dimmer is in the “RUN” position, it is operating in the
RUN
mode. This is
the normal operating mode of the dimmer. The
RUN
mode is used to recall preset
light levels and to manually raise and lower the lights.
Refer to the following table for a list of available functions when the dimmer is
operating in the
RUN
mode.
NOTE:
If the behavior of the -DIM4RF/-DIMS4RF has not been changed in
SIMPL™ Windows
®
, SystemBuilder™ or D3 Pro™, the only button that will
perform any function is Button 1. All of the other buttons are programmable.
RUN Mode Button Functions
FUNCTION -DIM1RF/
-DIMS1RF/
-SLVD1RF
BUTTON PRESS
-DIM4RF/-DIMS4RF
BUTTON PRESS
Dim to Preset 1.
Tap the Top button.
Tap Button 1. The light will
dim to Preset 1 if the light
level is = 0% (Off).
Dim to Preset 2 in
0.5 seconds.
Double-tap the Top
button.
Double-tap Button 1.
1
Dim to Preset 3 in
0.5 seconds.
Double-tap the Bottom
button.
Double-tap Button 1.
2
Dim to “Full Off”
(lighting level =
0%).
Tap the Bottom button.
Tap Button 1. The light will
dim to “Full Off” if the light
level is > 0% (Off).
Manually raise
light level.
Hold the Top button until
the desired lighting level
is reached.
Hold Button 1 until the desired
lighting level is reached.
3
Manually lower
light level.
Hold the Down button
until the desired lighting
level is reached.
Hold Button 1 until the desired
lighting level is reached.
3
1.
If load was at Preset 3 level or > 0% (Off), dim to Preset 2.
Operations Guide - DOC. 6396
infiNET Dimmers: Crestron CLW-DIM1/4RF, -DIMS1/4RF, -SLVD1RF
•
9
