CNX Dual Processor Modular Control System
Crestron
CNRACKX-DP
As of the date of manufacture, this unit has been tested and found to comply with
specifications for CE marking.
NOTE:
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Setup
Rear Faceplates
Blank faceplates for the empty expansion slots at rear of the CNRACKX-DP are
included but are not shipped installed. Ten faceplates (mounting screws included) are
provided and additional faceplates are available through Crestron’s Customer
Support. After any additional CNX expansion cards have been installed into the
CNRACKX-DP, install blank faceplates onto any remaining empty expansion slots.
CAUTION:
Do not over-tighten the faceplate mounting screws. Tighten screws to
4-
inch
pounds (.45 Nm).
Rack Mounting
WARNING:
To prevent bodily injury when mounting or servicing this unit in a
rack, take special precautions to ensure that the system remains stable. The following
guidelines are provided to ensure your safety:
The unit should be mounted at the bottom of the rack if it is the only unit in the
rack.
When mounting this unit in a partially filled rack, load the rack from the bottom
to the top with the heaviest component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before
mounting or servicing the unit in the rack.
NOTE:
If rack mounting is not required, rubber feet are provided for table-top
mounting or stacking. On the underside of the unit, apply two of the feet at the rear
corners and the remaining two approximately one inch from the front corners.
NOTE:
Reliable grounding of rack mounted equipment should be maintained.
Particular attention should be given to supply connections other than direct
connections to the branch circuit (e.g., use of power strips).
8
•
CNX Dual Processor Modular Control System: CNRACKX-DP
Operations Guide - DOC. 8151
