Hand-Held Wireless Transmitters
Crestron
CNRFHT-15A/30A
Specifications
The table below provides a summary of specifications for the transmitter.
Specifications of the CNRFHT-15A/30A Transmitter
SPECIFICATION DETAILS
Power Requirements
(1) 9VDC alkaline battery (included)
RF Specifications
1-Way Wireless RF Transmitter, 433.92 MHz (418
MHz CNRFHT-15A/30A/UK), Range up to 300 feet
1
Control System Update Files
2, 3, 4
2-Series Control System Update File
CEN/CN-TVAV Update File
CNMSX-AV/Pro Update File
CNRACKX/-DP Update File
ST-CP Update File
All Versions
Default RF ID
11
Operating Temperature
50° to 113°F (10° to 45°C)
Humidity
10% to 90% RH (non-condensing)
Dimensions
Height: 6.50.in (16.5 cm)
Width: 2.75 in (6.85 cm)
Depth: 0.80 in (2.03 cm)
Weight (without battery)
0.25 lb (0.11 kg)
1.
Requires Crestron CNRFGWA 1-Way RF Receiver, or ST-CP SmarTouch Control Processor.
2.
The latest versions can be obtained from the Downloads | Software Updates section of the Crestron
website (
. Refer to NOTE after last footnote.
3.
Crestron 2-Series control systems include the AV2, CP2, MP2, PAC2, PRO2, and RACK2.
4.
CNX update files are required for either CNMSX-AV/Pro or CNRACKX/-DP. Filenames for CNX
update files have a UPZ extension and ST-CP files are in one EXE or zipped UPZ file. To avoid program
problems, make certain you are using the update file with the correct suffix letter (e.g., S, V, W, X).
NOTE:
Crestron software and any files on the website are for Authorized Crestron
dealers only. New users may be required to register to obtain access to certain areas
of the site (including the FTP site).
Physical Description
The CNRFHT-15A/30A electronic hardware is housed in a slim, high-impact
molded ABS black plastic enclosure. Refer to the figure on the next page. A
customized button panel covers a 30-button array on the printed circuit board. All
button panels include custom engraving, colored button caps, choice of button
configurations, and panel finishes. Small and large button caps are available. A small
button cap covers one button. A large button cap covers two buttons, either
horizontally or vertically. Refer to “Custom Button Panel Engraving” on page 12 ,
for more information on designing custom button panels.
NOTE:
Crestron does not recommend designing large button caps for single
functions. Pressing the center of a large button cap can cause the unit to transmit
incorrectly which may result in the control system misinterpreting the user's intent.
Therefore, design large button caps for dual functions, such as a volume up/volume
down rocker-type button.
A red Transmit LED is located above the button panel cover. The battery
compartment on the rear of the unit holds one standard 9VDC alkaline battery.
2
•
Hand-Held Wireless Transmitter: CNRFHT-15A/30A
Operations Guide – DOC. 8092A
