Crestron
CNX-B2/B4/B6/B8/B12
Single Gang Keypads
Operations & Installation Guide - DOC. 8173A
Single Gang Keypads: CNX-B2/B4/B6/B8/B12
•
27
Uploading a SIMPL Windows Program
A control
system source
file has the
extension
.smw. A
compiled
SIMPL
Windows file
has the
extension .spz
for a 2-Series
control system,
.bin for CNX
generation,
and .csz for
CNX
generation
with SIMPL+.
.
The SIMPL Windows file can be uploaded to the control
system using SIMPL Windows or via the Crestron
Viewport.
Upload via SIMPL Windows
1. Start SIMPL Windows.
2. Select
File | Open
to view the “Open” window,
navigate to the SIMPL Window file (.smw),
and click
Open
.
3. Select
Project | Transfer Program
.
Upload via Crestron Viewport
1. Verify that the procedure for “Communication Settings” that
begins on page 23 has been performed.
2. As shown after this step, select
File Transfer | Send
Program
(alternatively, press
Alt+P
) from the Viewport
menu bar.
File Transfer | Send Program Command
3. The “Send Program” window appears, as shown on the next
page. Click
Browse
, locate the compiled file (.spz for PRO2)
and click
Open
. This will display the program's header
information and enable one or both of the
What to Send
check
boxes. If the program does not contain any SIMPL+ modules,
only the
SIMPL Program
check box will be enabled. If it does
contain SIMPL+ modules, then the
SIMPL+ Program(s)
check box will also be enabled. Select one or both check
boxes and then click
Send Program
to begin the transfer.
NOTE:
Refer to the respective Operations Guide for the control system
for details about the other fields shown on the “Send Program” window.
