Two-Way RF Transceiver Module
Crestron
CWD1014
6
•
Two-Way RF Transceiver Module: CWD1014
Operations Guide - DOC. 6658
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body. This transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter.
This device is intended only for OEM integrators under the following
conditions:
1.
The antenna must be installed such that 20 cm is maintained between the
antenna and users, and
2.
The transmitter module may not be co-located with any other transmitter or
antenna.
As long as the two conditions above are met, further transmitter test will not be
required. However, the OEM integrator is still responsible for testing their end-
product for any additional compliance requirements required with this module
installed (for example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE:
In the event that these conditions cannot be met (for
example certain laptop configurations or co-location with another transmitter), then
the FCC authorization is no longer considered valid and the FCC ID cannot be used
on the final product. In these circumstances, the OEM integrator will be responsible
for reevaluating the end product (including the transmitter) and obtaining a separate
FCC authorization.
OEM Note : Transmit Duration Limit
This device has been tested for FCC compliance under the condition that the
transmit duration does not exceed 58 mS over any 100 mS interval.
When transferring data through the transmitter, ensure that packet lengths do
not violate the above duration requirement; otherwise the FCC compliance
will be degraded and will invalidate the Grant of Authorization.
