Two-Way RF Transceiver Module
Crestron
CWD7567
4
•
Two-Way RF Transceiver Module: CWD7567
Operations Guide - DOC. 7019A
Setup
Hardware Hookup
Refer to the hookup diagram below, which shows the connections made to the module. Complete the
connections in any order.
NOTE:
To prevent unit-to-unit RF interference, multiple modules operating at the same frequencies
should not be installed within three to five feet of each other.
Host
+5V
Control
Orientation
The device is intended to be installed with the PCB perpendicular to the ground with the antenna at the
top as shown in the picture below.
Labeling
If the FCC identification number is not visible when the module is installed inside another device, then
the outside of the device into which the module is installed must also display a label referring to the
enclosed module. This exterior label can use wording such as the following: “Contains Transmitter
Module FCC ID: EROCWD7567” or “Contains FCC ID: EROCWD7567.” Any similar wording that
expresses the same meaning may be used.
