DM-TX-201-S and DM-TX-201-S2
DigitalMedia 8G™ Fiber Transmitters
DocType - 8680A
(2055420)
02.20
Getting Started
Scan the QR code to view the Quick Start Guide.
For additional information about the
DM-TX-201-S, visit
www.crestron.com/model/6504168.
For additional information about the
DM-TX-201-S2, visit
www.crestron.com/model/6506011.
Certification and Compliance
Regulatory Models: DM-TX-201-S, DM-TX-201-S2
Federal Communications Commission (FCC)
Compliance Statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the following conditions:
(1) This device may not cause harmful interference
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
l
Reorient or relocate the receiving antenna.
l
Increase the separation between the equipment
and receiver.
l
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
l
Consult the dealer or an experienced radio/TV
technician for help.
Industry Canada (IC) Compliance Statement
CAN ICES-3 (B)/NMB-3(B)
As of the date of manufacture, the product has
been tested and found to comply with
specifications for CE marking.
