Supplemental Guide — Doc. 8325B
DM-TX-4KZ-202-C and DM-TX-4KZ-302-C • 3
Ì
DM OUT: 8-pin RJ-45 female, shielded;
DM 8G+® output, HDBaseT standard compliant;
PoDM+ PD (Powered Device) port (HDBaseT PoE+ compatible);
Connects to the DM 8G+ input of a DM® switcher, receiver, or other DM device,
or to an HDBaseT® device via CAT5e, Crestron DM-CBL-8G, or Crestron
DM-CBL-ULTRA cable;
Green LED indicates DM link status;
Solid amber LED indicates HDCP video;
Flashing amber LED indicates non-HDCP video
NOTES:
l
In order to receive PoDM+, the DM OUT port requires connection to a
DigitalMedia switcher or other equipment that has a corresponding PoDM+
PSE (Power Sourcing Equipment) port. In order to receive HDBaseT PoE+,
the DM OUT port requires connection to equipment that has a
corresponding HDBaseT PoE+ PSE port. Wiring that is connected to a
PoDM+ or HDBaseT PoE+ PSE port is for intrabuilding use only.
l
For pin assignment information, refer to the
Í
HDMI OUT LED: Green LED, indicates HDMI signal presence at the HDMI output
Î
HDMI OUT: HDMI Type A connector, female;
HDMI digital video/audio output (DVI compatible)
NOTE:
l
The HDMI OUT port requires an appropriate adapter or interface cable to
accommodate a DVI signal. CBL-HD-DVI interface cables are available
separately.
l
4K60 4:4:4 performance and HDR support require the use of HDMI and
DisplayPort cables and couplers with a minimum TMDS bandwidth of 18
Gbps.
If 4K60 4:2:0 or 4K30 4:4:4 performance is acceptable, cables and couplers
with a minimum bandwidth of 10.2 Gbps can be used. Performance may be
reduced when using multiple cables and couplers.
Ï
HDMI IN 1–2 LEDs: Green LEDs, each indicates HDMI signal presence at the
corresponding HDMI input
