Crestron
DM-TX-200-2G/400-3G
Wall Plate DigitalMedia™ CAT Transmitters
“D” Cable (Cutting the Spline)
Cut Spline To Here
Cut Spline to Here
6.
Neatly wrap the twisted braid around the foil shield as shown in the
following illustration. Only the silver side of foil shield is conductive.
NOTE:
Braid should wind neatly around foil shield. Loose braid may cause
shorts.
“D” Cable (Wrapping the Twisted Braid)
7.
Strip the insulation from the ends of each wire, exposing approximately
3/16 inch (5 mm) of bare copper.
NOTE:
Do not allow the twisted pairs to untwist for more than 1/2 inch
(13 mm).
NOTE:
Maintain equal wire lengths within 1/8 inch (3 mm).
8.
Using an adjustable wrench, clamp the prepared cable to the unit as shown
in the following illustration.
NOTE:
Twisted braid and foil shield must be in full contact with inside of
clamp.
Operations & Installation Guide – DOC. 6949B Wall Plate DigitalMedia™ CAT Transmitters: DM-TX-200-2G/400-3G
•
19
Summary of Contents for DigitalMedia DM-TX-200-2G
Page 4: ......
