Crestron
DM-TX-200-2G/400-3G
Wall Plate DigitalMedia™ CAT Transmitters
D Terminal Block
c.
Insert the twisted pairs of the yellow, unshielded cable into the M
terminal block and tighten each screw base. Use the 568-B wiring
standard.
M Terminal Block
12.
Remove the pre-cut insulation from the grounding wire and connect it to the
electrical box or a ground wire in the electrical box (the electrical box must
be earth grounded).
13.
Attach the unit to the electrical box using the included #06-32 x 3/4" oval
head slotted screws as shown in the illustration on the following two pages.
CAUTION:
Excess wire pinched between the unit and electrical box could
cause a short. Make sure that all excess wire is completely inside the
electrical box and not between the box and the side of the unit.
14.
Attach an appropriate decorative style faceplate (not supplied).
Operations & Installation Guide – DOC. 6949B Wall Plate DigitalMedia™ CAT Transmitters: DM-TX-200-2G/400-3G
•
21
Summary of Contents for DigitalMedia DM-TX-200-2G
Page 4: ......
