Wall Plate DigitalMedia™ CAT Transmitters
Crestron
DM-TX-200-2G/400-3G
USB Communication via DM Switcher
USB
DM Switcher
PC Running
Crestron Toolbox
DMNet
DM-TX-200-2G
or
DM-TX-400-3G
To establish USB communication between the PC and the DM-TX-200-2G or
DM-TX-400-3G via a DM switcher:
1.
Use the Address Book in Crestron Toolbox to create an entry using the
expected communication protocol (USB). When multiple USB devices are
connected, identify the DM switcher by entering “DM-MD8X8”,
“DM-MD16X16” or “DM-MD32X32” in the
Model
textbox, the unit’s
serial number in the
Serial
textbox or the unit’s hostname in the
Hostname
textbox. The hostname can be sound in the “System Info” window in the
Ethernet
section of the window, however, communication must be
established in order to see this information in the “System Info” window.
2.
Display the DM-TX-200-2G or DM-TX-400-3G’s “System Info” window
(click the
icon); communications are confirmed when the device
information is displayed.
Via DM-RMC-100
TCP/IP Communication via DM-RMC-100
DM-RMC-100
PC Running
Crestron Toolbox
LAN
DM-TX-200-2G
or
DM-TX-400-3G
ETHERNET
The DM-TX-200-2G or DM-TX-400-3G connects to PC via Ethernet:
1.
Confirm Ethernet connection between DM-RMC-100 and PC. If connecting
through a hub or router, use CAT5 straight through cables with 8-pin RJ-45
connectors. Alternatively, use a CAT5 crossover cable to connect the two
LAN
ports directly without using a hub or router.
2.
By default, DHCP is enabled. Use the Device Discovery Tool in Crestron
Toolbox to find the IP address of the DM-TX-200-2G or DM-TX-400-3G.
To change the IP configuration, from Crestron Toolbox, display the
“System Info” window (click the
icon) and select the DM-TX-200-2G
or DM-TX-400-3G entry from the Address Book. Select
Functions |
Ethernet Addressing
and enter the new IP address, IP mask and default
router of the DM-TX-200-2G or DM-TX-400-3G.
NOTE:
If the DM-TX-200-2G is in a non-DHCP environment, a default IP
address (192.168.1.232) can be assigned by holding down its
SETUP
button while applying power. If the DM-TX-400-3G is in a non-DHCP
environment, a default IP address (192.168.1.235) can be assigned by
holding down its
SETUP
button while applying power. This IP address will
overwrite any previous settings and will remain until it is changed.
3.
Use the Address Book in Crestron Toolbox to create an entry for the
DM-TX-200-2G or DM-TX-400-3G with the DM-TX-200-2G’s or
DM-TX-400-3G’s TCP/IP communication parameters.
4.
Display the “System Info” window (click the
icon) and select the
DM-TX-200-2G or DM-TX-400-3G entry from the Address Book.
30
•
Wall Plate DigitalMedia™ CAT Transmitters: DM-TX-200-2G/400-3G Operations & Installation Guide – DOC. 6949B
Summary of Contents for DigitalMedia DM-TX-200-2G
Page 4: ......
