Wall Plate DigitalMedia™ CAT Transmitters
Crestron
DM-TX-200-2G/400-3G
Setup
Network Wiring
When wiring the DM network, consider the following:
NOTE:
DMNet wiring and Cresnet
®
wiring are not compatible.
•
Use Crestron Certified Wire.
•
Use Crestron power supplies for Crestron equipment.
•
Provide sufficient power to the system.
CAUTION:
Insufficient power can lead to unpredictable results or damage
to the equipment. Please use the Crestron Power Calculator to help calculate
how much power is needed for the system (
•
For DigitalMedia CAT wiring, use DM-CBL DigitalMedia Cable. Up to
two DM Repeaters (model DM-DR, sold separately) may be required. Refer
to the latest version of the Crestron DigitalMedia Design Guide (Doc. 4789)
for complete wiring guidelines.
For more details, refer to “Check Network Wiring” on page 34.
Identity Code
NOTE
: In the SIMPL™ Windows program, when a DM-TX-200-2G or
DM-TX-400-3G is dropped onto an input card of a DM switcher, its IP ID is
assigned automatically and does not require additional programming. Use the
information below when a DM-TX-200-2G or DM-TX-400-3G is dropped directly
into an Ethernet slot on the control system in SIMPL Windows, without a DM
switcher.
The IP ID is set within the DM-TX-200-2G’s and DM-TX-400-3G’s IP table using
Crestron Toolbox. For information on setting an IP table, refer to the Crestron
Toolbox help file. The IP IDs of multiple DM-TX-200-2G and DM-TX-400-3G
devices in the same system must be unique.
When setting the IP ID, consider the following:
•
The IP ID of each unit must match an IP ID specified in the SIMPL
Windows program.
•
Each device using IP to communicate with a control system must have a
unique IP ID.
16
•
Wall Plate DigitalMedia™ CAT Transmitters: DM-TX-200-2G/400-3G Operations & Installation Guide – DOC. 6949B
Summary of Contents for DigitalMedia DM-TX-200-2G
Page 4: ......
