66
•
DM-NVX-36x(C) Encoders/Decoders
Product Manual – DOC. 8879C
USB HID Hot Key Functionality
USB HID hot key functionality can be enabled or disabled using SIMPL Windows.
By default, USB HID hot key functionality is disabled. When enabled, USB HID hot key
functionality operates as follows:
•
Pressing the Scroll Lock key twice stops USB traffic from being transmitted to
the remote device (for example, a PC) and routes all keyboard data to the control
system.
•
Pressing C Shift + 0 through 9 sends digital joins high to trigger source
selection events (for example, source selection of a particular PC and USB
routing to and from the selected PC).
•
Pressing the Enter or Esc key exits hot key functionality and passes USB data to
the selected source.
Using SIMPL Windows, configure USB routing in Slot 30-01: USB Hotkey. For additional
information, refer to the SIMPL Windows help file.
Network Port Selection
Network port selection enables network traffic to be managed and segregated based on
traffic type. Internal VLANs are used to route different traffic types to specific external
Ethernet ports, and external Ethernet ports can then be assigned to the various traffic
types. AES67 or Dante audio can be separated from the primary video and control
network resulting in a dedicated audio network.
CAUTION:
When network port selection is set to Off (default setting), multiple Ethernet
ports cannot be connected to the same Ethernet switch. Doing so will cause a network
loop and bring down the network.
NOTE:
If network port selection is enabled, daisy chain configuration is not supported.
To configure network port selection:
1.
Click the Settings tab and then click Port Selection.
2.
Enable or disable network port selection by setting the Port Selection toggle
switch in the On (right) or Off (left) position, respectively. The default setting is
Off.
3.
If Port Selection is set to On, assign each of the following traffic types to a
specific Ethernet port:
•
Management (default setting is port 1). Ethernet ports 1, 2, 3, and 4 are
available for use.
NOTE:
The management port controls the connection to the DM NVX web
interface. Changing the port number will result in losing the connection to the
web interface.
•
Video (default setting is port 1). Ethernet ports 1, 2, and 4 are available for
use. Port 3 is 100BASE-TX only and is not available for use.
