DigitalMedia 8G+ Receiver
Crestron
DM-RMC-SCALER-C
16
•
DigitalMedia 8G+ Receiver: DM-RMC-SCALER-C
Operations & Installation Guide – DOC. 7231B
Supplied Hardware
The hardware supplied with the DM-RMC-SCALER-C is listed in the following
table.
Supplied Hardware for the DM-RMC-SCALER-C
DESCRIPTION
PART NUMBER QUANTITY
Mounting Bracket
2021253
1
Screws, 6-32 x 1”, Pan, Phil
2007250
4
Screws, 6-32 x 3/4”, Slot
2009211
4
Installation
Ventilation
The DM-RMC-SCALER-C should be used in a well-ventilated area. The venting
holes should not be obstructed under any circumstances.
To prevent overheating, do not operate this product in an area that exceeds the
environmental temperature range listed in the table of specifications.
Mounting the
DM-RMC-SCALER-C
The DM-RMC-SCALER-C mounts to a 2-gang electrical box (not included). To
mount the DM-RMC-SCALER-C, perform the following steps (refer to the
illustration on the following page):
1.
Using the four included 6-32 x 3/4” (2009211) slot head screws, attach the
included mounting bracket to the electrical box.
2.
Ground the DM-RMC-SCALER-C and attach the proper cable to the rear of
the unit (refer to “Hardware Hookup” on page 17 for information).
3.
Using the four included 6-32 x 1” (2007250) Phillips head screws, attach
the DM-RMC-SCALER-C to the mounting bracket.
CAUTION:
Excess wire that is pinched between the DM-RMC-SCALER-C and
the electrical box can short out. Ensure that all excess wire is completely inside the
electrical box and is not between the box and the DM-RMC-SCALER-C.
Summary of Contents for DM-RMC-SCALER-C
Page 4: ......
