Mounting into an Electrical Box
The transmitter mounts into a 1-gang electrical box (not included).
1. Using a Phillips screwdriver and the two included 6-32 x 3/4-inch truss
combo head screws, attach the transmitter to the electrical box.
2. Using the included faceplate assembly:
a. Position the rear faceplate onto the front of the transmitter.
b. Using the two included 6-32 x 1/4-inch Phillips flat head screws,
attach the rear faceplate to the transmitter.
c. Position the front faceplate over the rear faceplate and press the
front faceplate until it snaps into place.
Mounting into an Electrical Box
Mounting onto a Flat Surface
Mount the transmitter onto a suitable flat surface such as the underside
of a table.
1. Using a Phillips screwdriver and the two included 6-32 x 1/4-inch
SEMS screws, attach the included surface-mount bracket to the
transmitter.
2. Attach the bracket to the flat surface using the two surface-mount
screw slots and two mounting screws (not included).
Mounting onto a Flat Surface
DM-TX-4KZ-100-C-1G
Quick Start
2