For information about DM OUT connector pin assignments, refer to the
following illustration and table.
DM OUT Wiring
Pin Number
Wire Color
1
Orange/White
2
Orange
3
Green/White
4
Blue
5
Blue/White
6
Green
7
Brown/White
8
Brown
Upgrade the Firmware
Before using the device, upgrade the firmware. The latest firmware can be
downloaded from the
and
product page on the Crestron website (
).
Determine the IP Address
The physical configuration of the DM-TX-4KZ-202-C or
DM-TX-4KZ-302-C within a DigitalMedia 8G+ system determines how the
IP address of the transmitter is set:
l
If the transmitter is connected to a DigitalMedia switcher, the IP
address is configured by the switcher automatically. You do not need
to set the IP address.
l
If the transmitter is connected directly to a DigitalMedia 8G+ receiver
(commonly referred to as a standalone configuration in which no
DigitalMedia switcher is used), the IP address of the transmitter is
assigned using DHCP (Dynamic Host Configuration Protocol) by
default. If you wish to assign a static IP address, do either of the
following:
o
To assign the default static IP address of the transmitter, hold
down the SETUP button while the unit boots up. The default static
IP address, which is 192.168.1.251 for the DM-TX-4KZ-202-C and
192.168.1.252 for the DM-TX-4KZ-302-C, overwrites the current
setting.
o
To manually set a static IP address other than the default address,
use the Crestron Toolbox™ software.
4
DM-TX-4KZ-202-C and DM-TX-4KZ-302-C
Quick Start
DigitalMedia 8G+® 4K60 4:4:4 HDR Transmitters
