14
•
DMF-CI-8: DM NVX and DMCF Card Chassis
Supplemental Guide – DOC. 7861C
Disable DHCP
If DHCP is disabled on the IPv4 Setup screen, additional parameters are added to the
screen to allow a static IP address and associated settings to be assigned to the card.
IPv4 Setup Screen (DHCP Disabled)
_ DM-NVX-350C-00107_
IPv4 Setup
IPv4
Enable
DHCP
Disable
IP Addr
0 0 0 0
Subnet
0 0 0 0
Gateway 0 0 0 0
DNS1
0 0 0 0
DNS2
0 0 0 0
With DHCP disabled, configure the following settings:
NOTE:
To navigate from a parameter name (for example, IP Addr) to the list of available
octet settings for an address in dotted decimal notation, press the select push button or
the right push button on the navigation pad. A rectangle denotes a scrolling list of
available settings:
IP Addr
19
0 0 0 0
To scroll through the list of available octet settings (for example, 0, 1, 2, 3, and so on),
press the up push button or the down push button until the desired setting is displayed.
To move to the next octet in the address, press the right push button. To move to the
previous octet in the address, press the left push button. After navigating to the last
octet in the address and scrolling to the desired octet, press the select push button to
navigate to the next parameter name (for example, Subnet).
•
IP Addr: Navigate to the desired static IPv4 address.
•
Subnet: Navigate to the subnet mask address.
•
Gateway: Navigate to the gateway address.
•
DNS1: Navigate to the primary DNS server address.
•
DNS2: Navigate to the secondary DNS server address.
If any change is made to DHCP settings, the changes must be applied. Refer to
“Apply IPv4 DHCP Settings” on the following page.
Summary of Contents for DMF-CI-8
Page 4: ......