Crestron
DTT-17
DualTouch™ Technology Touchpanel
Alternative Mounting
The DTT-17 may be removed from the adjustable stand and remounted to a VESA
®
conforming mount arm or stand. The Video Electronics Standards Association
(VESA) is an international non-profit corporation that supports and sets industry-
wide interface standards for the PC, workstation, and computing environments.
VESA's Flat Display Mounting Interface (FDMI) Standard defines a set of mounting
interface standards for the complete range of flat displays with viewing areas ranging
in size from 102 mm (4") to 2286 mm (90") diagonal. FDMI supports a broad range
of mounting options including desktop, wall, overhead, mobile and specialty
mounting applications. Corresponding standards describe the interface mounting
pads, wall mount brackets and other mounting apparatus to be provided by mounting
equipment manufacturers. The complete standard is available on the VESA website.
The DTT-17 is VESA MIS-D, 100/75, C compliant, and is equipped with a
75 x 75 mm mounting hole pattern.
Follow these instructions for removing the adjustable stand and attaching the
DTT-17 to an alternative VESA conforming mount.
1. Turn off the system and disconnect all cables.
2. Protect the screen surface by placing the DTT-17 facedown on a soft cloth.
3. Remove the four screws that secure the stand.
4. Use four M4 regular screws, no longer than 15 mm, 7 mm wide with a 0.7
mm pitch to attach the new mounting.
NOTE:
Screws longer than 15 mm could damage the DTT-17.
CAUTION:
When attaching the DTT-17 to an alternate mounting platform, be sure
to follow all instructions supplied by the manufacturer.
y
DualTouch™ Technology Touchpanel: DTT-17
Operations Guide – DOC. 6343
16
