DualTouch™ Technology Touchpanel
Crestron
DTT-18
Grasp the worn tip with a pair of needle-
nose pliers, tweezers, or similar
instrument and pull out the tip.
Firmly slide the new tip (square end
first) into the barrel of the pen and press
in until it stops.
NOTE:
A badly worn pen tip may damage the surface.
Cleaning
Keep the pen and screen surface clean. Dust and dirt particles can stick to the pen
and cause wear to the screen surface. Regular cleaning will help to prolong the life of
your equipment.
•
To clean the outer casing, stand, and pen, use a soft cloth and a mild
detergent (such as dishwashing liquid) diluted in water. Do not use paint
thinner, benzene, alcohol or other solvents.
•
To clean the surface of the display screen, use an anti-static cloth or very
slightly dampened cloth. Apply only very light pressure and do not make
the screen surface wet. Never use detergents or solvents to clean the screen.
Alternative Mounting
The DTT-18 may be removed from the adjustable stand and remounted to a VESA
®
conforming mount arm or stand. The Video Electronics Standards Association
(VESA) is an international non-profit corporation that supports and sets industry-
wide interface standards for the PC, workstation, and computing environments.
VESA's Flat Display Mounting Interface (FDMI) Standard defines a set of mounting
interface standards for the complete range of flat displays with viewing areas ranging
in size from 102 mm (4") to 2286 mm (90") diagonal. FDMI supports a broad range
of mounting options including desktop, wall, overhead, mobile and specialty
mounting applications. Corresponding standards describe the interface mounting
pads, wall mount brackets and other mounting apparatus to be provided by mounting
equipment manufacturers. The complete standard is available on the VESA web site.
The DTT-18 is VESA MIS-D, 100/75, C compliant, and is equipped with a
75 x 75 mm mounting hole pattern.
Follow these instructions for removing the adjustable stand and attaching the
DTT-18 to an alternative VESA conforming mount.
1. Turn off the system and disconnect all cables.
2. Protect the screen surface by placing the DTT-18 facedown on a soft cloth.
3. Remove the four screws that secure the stand.
4. Use M4 regular screws, no longer than 10 mm, to attach the new mounting.
NOTE:
Screws longer than 10 mm could damage the DTT-18.
Operations Guide – DOC. 6290
DualTouch™ Technology Touchpanel: DTT-18
•
17
