DualTouch™ Technology Touchpanel
Crestron
DTT-18
Power Connector
A keyed 4-pin connector is provided for connection to the external power supply
(power supply included).
+
+
-
-
Front Panel Switch and LEDs
A power on/off switch and a green power LED are located in the upper right corner
of the DTT-18. The power LED lights green when power is applied and a video
signal is applied. The power LED glows orange when no video source is present.
A status LED lights up green when the DTT-18 senses the annotation pen.
Status LED
Power LED
Power Switch
Industry Compliance
As of the date of manufacture, the DTT-18 has been tested and found to comply with
specifications for CE marking and standards per EMC and Radiocommunications
Compliance Labelling.
NOTE:
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Operations Guide – DOC. 6290
DualTouch™ Technology Touchpanel: DTT-18
•
9
