3. Attach the side plate to the module by snapping the plastic clips on the
plate into the two slots on the module.
NOTE:
If the side plate must be removed, use a small, flat object
(such as a flat-head screwdriver) to carefully pry the plastic clips on
the side plate off of the module near the two slots.
4. Feed the other end of the cable through an empty module slot in the
FT2-700 assembly.
5. Slide the pass-through cable module into the same module slot as
mentioned in the previous step. Use the guide ribs on the front and
rear of each module to help position the module in the FT2-700
assembly.
Installing the Pass-Through Cable Module with Non-4K
Cables
The grommet is recommended to use with cables that are 10 mm or
thinner.
1. Open the grommet.
2. Insert a cable into the grommet with the connector facing up toward
the end user.
3. Press the grommet back together to secure the cable inside.
4. Push the grommet and cable through the hole in the cable plate.
5. Insert the cable plate into one of the three slots in the pass-through
module. Choose the appropriate slot based on the length of the cable
connector. The top of the connector should sit flush with the top of the
module.
NOTES:
l
If the connector extends past the top of the pass-through
module, the FT2-700 assembly lid cannot close.
l
Ensure that the cable moves freely in the module prior to
attaching the side plate. The plate is difficult to remove once it is
attached.
5
FT2-700-MECH Series
Quick Start
FlipTop™ FT2 Series, 700 Size, Mechanical
