Replace the FT-600 FlipTop Assembly
An FT2-700 assembly may replace an FT-600 FlipTop assembly and use
the existing mounting hole. The FT-600 FlipTop assembly mounting hole is
larger than the mounting hole required for the FT2-700 assembly. The
included plastic spacers are used to help fill the gap between the mounting
hole and the FT2-700 assembly.
1. Loosen the four socket screws that secure the two mounting plates
and the FT-600 FlipTop assembly to the surface.
2. Remove the FT-600 FlipTop assembly.
3. Attach the four plastic spacers (included) to each corner of the
FT2-700 assembly.
4. To continue mounting the FT2-700 assembly, refer to
.
Secure the FlipTop Assembly
To secure the FT2-700 assembly to the table surface:
1. Ensure that all four swiveling dogs are tucked inside of the FT2-700
assembly, and then insert the FT2-700 assembly into the mounting
hole until the top lip is flush with the table surface.
2. Carefully tighten the four swiveling dogs in each corner of the FlipTop
assembly clockwise until the FT2-700 assembly is secured in place
against the table. Do not overtighten the swiveling dogs.
CAUTION:
A manual torque screwdriver may be used to hand
tighten the swiveling dogs. Set the torque screwdriver to its lowest
setting to avoid stripping the swiveling dogs and damaging the
table. If removing the FT2-700 assembly from the table, ensure
that the screwdriver rotation is set correctly before loosening the
swiveling dogs.
3
FT2-700-MECH Series
Quick Start
FlipTop™ FT2 Series, 700 Size, Mechanical
