FlipTop Touch Screen Control System
Crestron
FT-TSC600
16
•
FlipTop Touch Screen Control System: FT-TSC600
Operations & Installation Guide – DOC. 7593A
Configuring the Touch Screen
NOTE:
The only connection required to configure the touch screen is power. Refer
to “Hardware Hookup” on page 33 for details.
NOTE:
The FT-TSC600 can take up to 45 seconds to boot to a display after initial
power up.
Access the Setup Screens
The “Setup” menu is the starting point for configuring the FT-TSC600.
NOTE:
If no project has been loaded or if an invalid project has been loaded, the
screen displays a message saying “There is no display project to start. [Touch Screen
to Enter Setup…]”
The setup screens enable basic configuration procedures prior to regular operation of
the touch screen.
During regular operation of the touch screen, there are two ways to activate the setup
functions:
1.
Place a button on the project main page and assign the reserved join number
(17242) that activates setup.
2.
Press hard keys 1, 2, 3 and 4, to the right of the touch screen display, in
sequence twice (i.e., press 1, 2, 3, 4, 1, 2, 3, 4) within a 5 second period.
Button Numbering
4
3
2
1
The “FT-TSC600 Setup” menu is displayed.
