Hatch Back & Swivel Mount Kits
Crestron
HBK-3000 & SMK-3000
5. Put the Metal Bracket in position on the rear of the touchpanel
base (mounting holes should align, and standoff posts should be
oriented as shown in the illustration). Secure the Metal Bracket to
the touchpanel using the two screws
A
removed in step 4.
6. Refer to the illustration on page 5, and route the cables from the
interface box up through the Metal Plate, through the mounting
surface and through the Swivel Assembly, then through the area
of the bracket shown in the figure, and connect to the appropriate
touchpanel ports. Route the cables carefully to avoid chafing.
7. Being careful to avoid damage to the cables, attach the Swivel
Assembly to the base of the touchpanel, using the supplied four
#6-32 X 1/2 inch screws
C
through the swivel assembly standoff
posts into the threaded holes in the touchpanel base. Make certain
the cables are not twisted or crimped and have sufficient slack at
the port connections before fully tightening the screws.
8. Make certain tab
D
is positioned to the front of the swivel
assembly, and that it is directly opposite bent tab
F,
and place the
touchpanel and swivel mount assembly down on the Mounting
Surface.
9. Hold the Metal Plate in position under the mounting surface and
secure the assembly in place using the #8-32 screws
G
provided
(use the 5/8-inch screws for surfaces 3/4-inch to 1 1/8-inches
thick; use the 1-inch screws for surfaces 1 1/8 to 1 3/8 inches
thick). Use screws
E
to adjust tension of the swivel assembly.
10. Again, refer to the HBK-3000 illustration on page 3, and put the
Plastic Cover in position and secure to the Metal Bracket using
the four #4-40 X 3/16-inch screws
B
supplied.
4
•
Hatchback & Swivel Mount Kits: HBK-3000 & SMK-3000
Installation Guide – DOC. 6110
