b. Release the button to start the acquire process. The top
button’s LED flashes red slowly to show that the device is
actively scanning the infiNET EX network.
l
The top button’s LED lights red for 5 seconds to show
that the device has been successfully acquired to the
infiNET EX network.
l
The top button’s LED flashes red quickly to indicate that
the device was not successfully acquired by the infiNET
EX network. Tap the setup button to acknowledge failure
to acquire the infiNET EX network. Before attempting the
acquire process again, ensure one of the following:
o
The gateway is in Acquire mode and within range.
o
A non-battery powered infiNET EX device is in Acquire
mode on the same gateway.
3. Once all devices have been acquired, take the gateway out of Acquire
mode. Refer to the gateway’s manual for details.
Leaving an infiNET EX Network
To leave an infiNET EX network, put the device into Acquire mode. Ensure
that no gateway is in Acquire mode when removing a device from an
infiNET EX network.
To place a device into Acquire mode, refer to step 2 in
Verifying Communications Status
To check the communications status of the device, tap the top button
three times and then press and hold it down (tap-tap-tap-press+hold) for
up to 2 seconds. The button must be released before the LEDs flash to
indicate the communications status. Refer to the following table for
details.
NOTES:
l
If a side-to-side rocker is in the top position, either side of the rocker
can be pressed and held.
l
If there is a communication error and a remote button is pressed, all
of the LEDs will flash red in one of the patterns described in the table
below.
LED
Communications Status
Turns on
for 5
seconds
The device is communicating with the control system.
Flashes
three times
The device is communicating with the gateway, but the
gateway is not communicating with the control system.
Flashes
twice
The device was previously joined to the network but is not
communicating with the gateway.
Flashes
once
The device is not joined to the network.
9
HZ-KPEX
Quick Start
Horizon™ In-Wall Keypad with infiNET EX® Wireless Communication, 120 VAC