Crestron
IM-WCVI
iMedia Wall Plate Computer Center with Video Interface
iMedia Wall Plate Computer
Center with Video Interface:
IM-WCVI
Introduction
Features and Functions
•
Separate interface panel for use IM-WCVP iMedia Wall Plate Computer
Center with Video Control Panel
1
•
Connects to IM-WCVP to create IM-WCCV-S Wall Plate Computer
Center with Video using CresCAT™-IM iMedia cable or other high
quality CAT5 cable (up to 40 feet)
2
•
Connects PC and composite video (with audio) sources to iMedia systems
•
Mounts in a standard, 2½ inch deep, double-gang electrical box
1.
The IM-WCVI is part of the IM-WCCV-S. It must be used with the IM-WCVP.
2.
For more information on CresCAT-IM cable, refer to “IM Wiring” on page 7.
The iMedia Transport
The iMedia transport utilizes a single CAT5e* type cable to transmit computer RGB,
video, and stereo audio signals to a single projector or plasma display. A typical
XGA signal (1024 X 768 pixels at 60Hz) can be transmitted up to 84 feet using
iMedia, while higher resolutions up to 1600 x 1200 can be handled over shorter
distances. Composite video signals can be transmitted up to 218 feet. Audio is
transmitted digitally at 20-bit, 48 kHz resolution. Control and power signals are also
contained on the same wire, eliminating the need for separate control or power
cables.
*
For iMedia use CresCAT-IM cable, or quality CAT5e/CAT6 cable having a maximum delay skew
of 15ns per 100m.
2-Piece Wall Plate Multimedia Interface
The IM-WCCV-S is an iMedia (IM) transmitter featuring separate wall plates for
interface and control. The interface panel (IM-WCVI) is designed to install in a
Operations & Installation Guide – DOC. 6488
iMedia Wall Plate Interface: IM-WCVI
•
1
Summary of Contents for IM-WCVI
Page 4: ......
