Crestron
IM-WCVI
iMedia Wall Plate Computer Center with Video Interface
Specifications
Specifications for the IM-WCVI are listed in the following table.
IM-WCVI Specifications
SPECIFICATION DETAILS
Video Formats
RGB
Video
Gain
Max. Input Voltage
Input
Impedance
Resolutions
RGBHV (VGA), RGBS, RGsB, composite
R/G/B: 0 dB (unity gain, 75 ohm termination)
R/G/B: 1.0 V
PP
H/V: 5 V
PP
R/G/B: 75 Ohms
H/V: 1k Ohms
Supports videos up to XGA @ 60 Hz vertical
rate with maximum cable length of 84 feet and
maximum compensation at receiver. For
higher pixel resolutions (up to 1600 X 1200
pixels at 60 Hz vertical rate) refer to the chart
on page 8.
Composite
Video
Gain
Max. Input Voltage
Input
Impedance
Bandwidth
Composite: 0 dB (unity gain, 75 ohm
termination)
1.0 V
PP
75 Ohms
> 100 MHz (-3 dB) at unity gain
Audio
Max. Input Level
Input
Impedance
Audio Analog /
Digital
conversion
Frequency
Response
2 V
RMS
10k Ohms
20-bit, 48 kHz
20 Hz to 20 kHz
Power Requirements
Power is provided by the iMedia receiver
via the IM transport
Environmental
Temperature
Humidity
41° to 104°F (5° to 40°C)
10% to 90% RH (non-condensing)
Enclosure
Requires 2.5 inch deep double-gang
electrical box
Dimensions
Height
Width
Depth
4.50 in. (11.43 cm)
4.56 in. (11.58 cm)
2.64 in. (6.71 cm)
Weight
14.7 oz. (417 g)
Operations & Installation Guide – DOC. 6488
iMedia Wall Plate Interface: IM-WCVI
•
3
Summary of Contents for IM-WCVI
Page 4: ......
