6.4 Inch Tilt Touchpanel
Crestron Isys
®
TPS-3000
HEADPHONES
Connect this standard mini phone jack
(12 mW, 32 ohms load) to the plug of an external
headphone set, not supplied. The headphone
output is for WAV and Line only. It does not send
out the microphone signal. Use the MIC OUT on
the TPS-IMPC for the microphone signal.
Tip
Ring
Ground
NOTE:
The headphone jack is unavailable after the HBK-3000 Hatchback option is
installed.
AUDIO
This 8-position, RJ-45 connector (color coded blue) mates with the TPS-IMPC
interface module and provides differential/single ended audio input and output. It
also produces line level differential output. Pinout description is shown in the table
after this paragraph.
AUDIO Pinouts
PIN #
DESIGNATION
DESCRIPTION
1
L+
Left Input (Positive)
2
L-
Left Input (Negative)
3 GND
Ground
4
R+
Right Input (Positive)
5
R-
Right Input (Negative)
6
S
Shield
7
M+
Mic Output (Positive)
8
M-
Mic Output (Negative)
1
8
1
8
Front
Top
To determine the location of pin 1, hold the connector so that the cable is down and
the clip is facing away from you. The copper connector on the far left is pin 1.
RS-232
This 6-position RJ-11 mates with a serial port of a PC; connecting cable is not
supplied. Use this port for direct connection to the PC to load files to a touchpanel
without a network connection. In the event that modular cables or an RJ-11 to DB9F
adapter is not available, the diagram and table that follows provide information so
that the cable can be fabricated on site.
PC to TPS-3000 Cable Specifications
18
•
6.4 Inch Tilt Touchpanel: Crestron Isys
®
TPS-3000
Operations Guide – DOC. 6076A
