6.4 Inch Tilt Touchpanel
Crestron Isys
®
TPS-3000
File Transfer | Send Touchpanel Command
3. As shown after this step, select the Net ID of the TPS-3000 touchpanel and
then click
OK
. The “Touch Panel Transfer” window appears (refer to the
following graphics).
“Select Network ID” Window
Check
Send Direct to Wired Touchpanel
if connected via RS-232 directly to
touchpanel.
NOTE:
When transferring any Cresnet file (touchpanel project/firmware), lower the
port speed baud rate to 38400 to match the Cresnet bus speed.
“Touch Panel Transfer” Window
\
TPS-3000 1-Way\generalist
Each time a project is selected
using the
Browse
command, that
project is added to the
File Name
drop-down list. This makes it
convenient to recall projects
without need to browse to a
directory. To delete the list click
Clear History
.
TPS-3000
All Files in Project
: sends the
entire project.
Only Changed Files
: sends only
the files that are different from
those that are currently stored in the panel. Note that if any pages in the
panel are not present in the project, those pages will be deleted from the
panel.
Additional choices include
Do not send graphic files
and
Do not send
sound files
. These are often very large files that take a long time to
load.
4. Click
Browse
. The “Open” window appears as shown in the following
illustration.
36
•
6.4 Inch Tilt Touchpanel: Crestron Isys
®
TPS-3000
Operations Guide – DOC. 6076A
