Product Manual — Doc. 9324A
IV-SAM-VXP-1B and IV-SAM-VXS-1B • 31
NOTE: Lowering this value increases switch speed. If any motion or zooming is
observed during switching, increase this value.
l
Noise Delay: Determines how long a noise needs to occur before the system recognizes it.
This feature helps to avoid switching based on coughs or other short sounds.
l
Pause Delay: Determines how long after an active participant stops speaking before the
camera will switch to another camera or a default shot.
Advanced Settings
Select the Advanced tab to view the available advanced settings.
Advanced Tab
The following advanced settings can be configured.
Room Configurations
The Room Configurations setting allows for different microphones and room furniture
arrangements to be used. This is especially helpful within divisible and multipurpose rooms.
Each room configuration saves a separate copy of all the settings in the Automate VX system.
NOTE: The camera presets assigned to the Microphone Table are different for each room
configuration.
Room Configurations Settings
To change room configurations, use the drop-down menu to select the desired room
configuration. Information for the room configuration is shown in the table below the drop-down
menu.
NOTE: Loading a room configuration will discard any unsaved changes on your current room
configuration. Ensure any changes are saved prior to making a new selection.
Selecting a room configuration can also be called with an API or Crestron command.
