![background image](http://html.mh-extra.com/html/crestron/mmk-3000l/mmk-3000l_installation-manual_2684503007.webp)
Crestron
MMK-3000L & WMKM-3000L
Mud Mount Kits
7. Use four standard drywall screws (length should not exceed drywall
thickness by more than ½ inch) to secure the mud ring plate to the rest
of the assembly. The screws pass through the clearance holes in the
PMK-3000L (or BB-3000L) and are secured in the extruded holes of
the fastener plates.
8. Verify that the mud ring plate is level.
NOTE:
Do not over tighten screws. Doing so may over-dimple or rip the mud ring
plate.
9. Use a #2 Phillips screwdriver and tighten the drywall screws by hand
so that they slightly dimple into the holes in the mud ring plate.
10. Apply drywall joint compound as needed to finish the cutout. Avoid
covering the 4 tapped mounting holes.
11. Run the necessary cables for the touchpanel and secure them behind the
drywall.
12. When dry, the TPS-3000L can be installed using the four tapped holes
in the PMK-3000L. Refer to the latest revision of the TPS-3000L
Operations Guide (Doc. 6077) for details.
WMKM-3000L Procedure
The procedure in this section provides the necessary steps for the assembly and
installation of the WMKM-3000L into a wall. Complete the steps in the order
provided. The only tools or materials required and not supplied are a drywall saw or
equivalent, a level, four standard drywall screws, #2 Phillips screwdriver, and
tools/material to apply drywall joint compound.
1. Insert the two pins on one fastener plate into the top two outer holes on
the mounting plate, as shown in the illustration after this step.
Create the Fastener/Mounting Plate Assembly
Installation Guide – DOC. 6021
Mud Mount Kits: MMK-3000L & WMKM-3000L
•
5
MOUNTING PLATE
FASTENER PLATE
(4) PUSH-ON FASTENER