Multimedia Presentation System 250
Crestron
MPS-250
•
Adjust the Record Volume level by turning the volume control clockwise to
raise the volume, or counterclockwise to lower the volume. When adjusting
the Record Volume level, the display will change to indicate the volume
level.
NOTE:
The Record Volume can only be used if the Fixed/Variable Mode
is set to “Variable”. For more information, refer to “Set Fixed/Variable
Mode” on page 50.
Set the Record Source Mix
To set the
RECORD
output’s source mix:
•
Access the Record Output menu as described on page 49.
•
Press
ENTER
to open the Record Source Mix controls.
Record Source Mix Controls
Record Source Mix
Aud. Only
•
Press the
k
or
j
buttons until the desired setting is displayed on the LCD.
The current setting is indicated with an asterisk (*). The following settings
are available:
⇒
Aud. Only
: Sends the audio signal from the selected source to the
RECORD
output.
⇒
Mic. Only
: Sends the microphone input signals to the
RECORD
output.
⇒
Mic + Aud
: Sends a mix of the audio signal from the selected source
and the microphone input signals to the
RECORD
output.
NOTE:
While setting the Record Source Mix, the Record Volume
level can be adjusted by turning the volume control clockwise to raise
the volume, or counterclockwise to lower the volume. When adjusting
the volume, the display will change to indicate the volume level.
•
Press
ENTER
to save changes and return to the previous screen. To cancel
without saving changes, press
MENU
.
Set Fixed/Variable Mode
The
RECORD
output can be set to operate at a fixed level or a variable level. The
SPEECH
and
PROGRAM
outputs are not affected by changes made to the
Fixed/Variable mode.
To adjust the Fixed/Variable Mode:
•
Access the Record Output menu as described on page 49.
•
Press the
k
or
j
buttons until “Fixed/Variable” is displayed on the LCD
and press
ENTER
to open the Fixed/Variable control.
50
•
Multimedia Presentation System 250: MPS-250
Operations Guide – DOC. 6647A
