Crestron
MPS-250
Multimedia Presentation System 250
•
Press
MENU
or
ENTER
to save changes and return to the previous screen.
Adjust the Speech Startup
Volume
The Speech Startup Volume control is used to establish the
SPEECH
output’s
volume level setting when an input is selected. The
RECORD
and
PROGRAM
outputs are not affected by changes made to the Speech Startup Volume level.
To adjust the Speech Startup Volume level:
•
Access the Speech Output menu as described on page 43.
•
Press the
k
or
j
buttons until “Startup Vol.” is displayed on the LCD and
press
ENTER
to open the Speech Startup Volume control.
Speech Startup Volume Control
Spch. Startup Vol.
30%
•
Adjust the Speech Startup Volume level with the
j
and
k
buttons. Press
the
k
button to increase the Speech Startup Volume level. Press the
j
button to lower the Speech Startup Volume level. The highest Speech
Startup Volume setting is 100%.
NOTE:
While adjusting the Speech Startup Volume level, the Speech
Volume level can be adjusted by turning the volume control clockwise to
raise the volume, or counterclockwise to lower the volume. When adjusting
the volume, the display will change to indicate the volume level.
•
Press
MENU
or
ENTER
to save changes and return to the previous screen.
Record Output
The
Record Output
section of the Audio Setup menu is used to set the
RECORD
output’s volume level, source mix, output mode, and startup volume. The
PROGRAM
and
SPEECH
outputs are not affected by changes made to the Record
Output controls.
Access the Record Output
Menu
To access the Record Output menu:
•
Access the Audio Setup menu as described on page 38. The words “Audio
Setup” will be displayed.
•
Press the
k
or
j
buttons until “Record Output” is displayed on the LCD
and press
ENTER
to open the Record Output menu.
•
To return to the Audio Setup menu, press
MENU
.
Set the Record Volume Level
To set the Record Volume level:
•
Access the Record Output menu as described above.
Operations Guide – DOC. 6647A
Multimedia Presentation System 250: MPS-250
•
49
