Crestron
MPS-250
Multimedia Presentation System 250
Front Panel Lock Controls
Front Panel Lock:
On
•
Press the
k
or
j
buttons to toggle between On and Off. The current setting
is indicated with an asterisk (*).
•
Press
ENTER
to save the new setting and return to the Control Setup
menu.
Operation
Using the out-of-the-box functionality, the MPS-250 can be operated from the front
panel, an APAD, a 12-button keypad such as the CNX-B12 or the C2N-DB12, or the
C2N-FTB FlipTop Control Center.
Control from the Front Panel
The following describes operation of a system when using the out-of-the-box
functionality and the front panel. If a custom program has been created, the system
may function differently.
Turn On the System
To turn on the system:
1.
Select an output by pressing any of the output buttons:
•
VIDEO
for composite output on
OUTPUT 1
.
•
S-VIDEO
for S-video output on
OUTPUT 2
.
•
YPrPb
for component output on
OUTPUT 3
.
•
RGBHV
for RGB video on
OUTPUT 4
.
•
TOUCHPANEL
for local touchpanel on
OUTPUT
5
(CH or QM).
2.
Select any of the source inputs by pressing an input button (
BNC 1
,
BNC 2
,
RGBHV 3
,
BNC 4
,
RGBHV 5
, or
QM IN 6
).
Turn Off the System
To turn off the system, press the
SYS PWR
button twice.
NOTE:
If the projector output was selected (output button 1), the display will
prompt the user to turn off the projector.
Lower the Projection Screen
Press the function button labeled
SCREEN DOWN
to lower the projector screen.
NOTE:
This function will only work if a projection screen’s control lines have been
connected to
RELAY
1
(up control) and
RELAY 2
(down control).
Operations Guide – DOC. 6647A
Multimedia Presentation System 250: MPS-250
•
75
