Wall Plate Media Center
Crestron
QM-WMC
To determine which pin is number 1, hold the cable so that the end of the
eight-pin modular jack is facing you, with the clip down and the copper
side up. When looking down at the copper connections, pin 1 is on the far
right. The following table lists the pin assignments on the RJ-45
connector.
Pin and Pair Assignment
RJ-45
PIN #
CAT5E
PAIR #
WIRE COLORS
(568B)
QM
ASSIGNMENT
RGB AND
AUDIO
QM ASSIGNMENT
COMPOSITE,
S-VIDEO AND
AUDIO
1
2
WHITE/ORANGE
- RGB RED
- CHROMINANCE
2
2
ORANGE
+ RGB RED
+ CHROMINANCE
3
3
WHITE/GREEN
- RGB GREEN
- LUMINANCE
4
1
BLUE
+ AUDIO
+ AUDIO
5
1
WHITE/BLUE
- AUDIO
- AUDIO
6
3
GREEN
+ RGB GREEN
+ LUMINANCE
7
4
WHITE/BROWN
- RGB BLUE
- COMPOSITE
8
4
BROWN
+ RGB BLUE
+ COMPOSITE
NOTE:
When using Crescat-QM wiring, a cable containing four wires is
included for making Cresnet connections.
Identity Code
All equipment and user interfaces within the network require a unique
identity code (Net ID). These codes are two-digit hexadecimal numbers
from 03 to FE. The Net ID of each unit must match an ID code specified
in the SIMPL Windows program. Refer to “Setting the Net ID in Device
Settings” on page 31 for details of the SIMPL Windows procedure.
Refer to the note
on page 34 for a
definition of
Viewport.
The Net ID of the QM-WMC has been factory set to
04
. The Net IDs
of multiple QM-WMCs in the same system must be unique. Net IDs
are changed from a personal computer (PC) via the Crestron Viewport.
NOTE:
For detailed information on establishing communication
between the PC and control system, refer to “Communication Settings”
on page 35. If communication cannot be established, refer to the
18
•
Wall Plate Media Center: QM-WMC
Operations & Installation Guide - DOC. 6237A
