Crestron ST-PC, Operation Manual

Crestron

 ST-PC 

Dual AC Power Control

Module

Setup 

Identity Code 

Refer to the note on page 12 for a 
definition of Viewport. 

All equipment and user interfaces within the network require a unique identity code 
(Net ID). These codes are two-digit hexadecimal numbers from 03 to FE. The Net 
ID of each unit must match an ID code specified in the SIMPL Windows program. 
Refer to “Setting the Net ID in Device Settings” on page 11 for details of the SIMPL 
Windows procedure.  

The Net ID of the ST-PC has been factory set to 

2C

, The Net IDs of multiple ST-

PCs in the same system must be unique. Net IDs are changed from a personal 
computer (PC) via the Crestron Viewport. 

NOTE:

 For detailed information on establishing communication between the PC 

and control system, refer to “Communication Settings” on page 13. If 
communication cannot be established, refer to the “Troubleshooting 
Communications” section in the respective Operations Guide for the control system. 

Use the following instructions to set or change the Net ID. 

1.  Ensure that the device requiring a Net ID change is the only unit connected 

to the control system.  

2.  Open the Crestron Viewport.  

3.  From the Viewport menu, select 

Functions | Set Network ID

. The software 

checks the baud rate and then opens the "Set Network ID" window.  

4.  In the "Set Network ID" window, select the device requiring a Net ID 

change from the 

Current Network Devices

 text window.  

5.  Select the new Net ID for the device from the 

Choose the new network ID 

for the selected device (Hex):

 text box.  

6. Click 

Set ID

 to initiate the change. This will display the "ID command has 

been sent" window.  

7.  In the "Command Complete" window, click 

OK

.  

8. In 

the 

Current Network Devices

 text window, verify the new Net ID code.  

9.  In the "Set Network ID" window, click 

Close

.  

NOTE: 

The new Net ID code may also be verified by selecting 

Diagnostic | Report 

Network Devices

 in the Viewport (alternately, select 

F4

).  

10.  Repeat this procedure for each additional network device requiring a Net ID 

change. 

Hardware Hookup 

Refer to the following hookup diagrams. Other than making the power connection 
last, complete the connections in any order.  

CAUTION: 

Use only Crestron power supplies for Crestron equipment. Failure to do 

so could cause equipment damage or void the Crestron warranty. 

Operations Guide – DOC. 5708A 

Dual AC Power Control Module: ST-PC  

•

  7