Crestron ST-PC, Operation Manual

Crestron

 ST-PC 

Dual AC Power Control

Module

NOTE:

 The parameters shown in the illustration above are the port settings for a 2-

Series control system. Consult the Operations Guide for the control system being 
used for the exact parameter selection. 

4.  To verify communication, select 

Diagnostics | Establish Communications 

(Find Rack)

. This should display a window that gives the COM port and 

baud rate. If communications cannot be established, refer to the 
“Troubleshooting Communications” section in the respective Operations 
Guide for the control system. 

Uploading a SIMPL Windows Program 

A control system source file has 
the extension .smw. A compiled 
SIMPL Windows file has the 
extension .spz for a 2-Series 
control system, .bin for CNX 
generation, and .csz for CNX 
generation with SIMPL+. 

The SIMPL Windows file can be uploaded to the control system using SIMPL 
Windows or via the Crestron Viewport. 

Upload via SIMPL Windows 

1.  Start SIMPL Windows. 

2. Select

 File | Open

 to view the “Open” window, navigate to the SIMPL 

Window file (.smw), and click 

Open

. 

3. Select 

Project | Transfer Program

. 

Upload via Crestron Viewport 

1.  Verify that the procedure for “Communication Settings” that begins on 

page  13  has been performed. 

2.  As shown after this step, select 

File Transfer | Send Program

(Alternatively, press 

Alt+P

) from the Viewport menu. 

File transfer | Send Program Command 

3.  The “Send Program” window appears as shown after this step. Click 

Browse

, locate the completed file (.spz for PRO2) and click 

Open

. This 

displays the program’s header information and enables one or both of the 

What to Send

 check boxes. If the program does not contain any SIMPL+ 

modules, only the 

SIMPL Program

 check box is enabled. If it does contain 

SIMPL+ modules, then the 

SIMPL+ Program(s)

 check box will also be 

enabled. Select one or both check boxes and then click 

Send Program

 to 

begin the transfer. 

NOTE:

 Refer to the respective Operations Guide for control system details about the 

other fields in the “Send Program” window. 

Operations Guide – DOC. 5708A 

Dual AC Power Control Module: ST-PC  

•

  15