Crestron
TPMC-4SMD
4.3” Designer Touch Screen
TPMC-4SMD with No-Button Covers
Installation
The TPMC-4SMD touch screen installs simply and cleanly into a standard electrical
box or on to virtually any flat surface.
A table top enclosure, the TTK-4SM and swivel mount, SMK-4SM are also
available (both sold separately). For mounting onto a flat surface, use the
MSMK-4SM Multi-Surface Mounting Kit (sold separately).
The TPMC-4SMD is supplied with screws for installation into an electrical box.
Mounting in a US Electrical Box
NOTE:
When mounting the TPMC-4SMD into an electrical box, the box must be
installed horizontally.
To mount the TPMC-4SMD into an electrical box, use the following procedure:
1.
Insert a small slot head screwdriver into the hole shown in the following
illustration and gently separate the back of the TPMC-4SMD.
Insertion Point for Separation of Back Panel
Insert screwdriver to separate back of TPMC-4SMD
2.
Use the two included #06-32 x 1 1/2” screws (2007254) to attach the back
panel to a horizontally mounted electrical box, as shown in the following
illustration.
Operations & Installation Guide – DOC. 7027E
4.3” Designer Touch Screen: TPMC-4SMD
•
23
