Crestron TPS-4500IMPC, Operation Manual

Crestron 

TPS-4500IMPC

Interface 

Module

CAUTION:

 The 10-pin RJ-45 net/video connector cable supplied by 

Crestron is a custom cable and is the only one that should be used. The 
end of the cable has a metal shield that is required to protect the 
equipment. Using non-Crestron cables will result in damage to the 
product. 

BAL/COAX 

While not a port, these DIP switches are used to select which video 
connections (balanced or unbalanced) to use when receiving video 
signals. When used with a TPS-4500 with TPS-VID-2 installed, each 
composite video signal can come in on either the twisted pair (balanced) 
or coaxial (unbalanced) connector. When used with a TPS-4500V or 
TPS-4500 with TPS-VID-1 installed, the video signal (S-video or 
composite) can be received over the twisted pair (balanced) or coaxial 
(unbalanced) connectors. As long as a switch is in the appropriate 
position, a signal can be connected to either the BNC or twisted-pair 
connector. 
To select the twisted pair connector for balanced video, the DIP switch 
for the respective video source must be in the “UP” position. To use the 
coaxial connector(s) for unbalanced video, the DIP switch must be in the 
“DOWN” position. 

Industry Compliance 

As of the date of manufacture, the TPS-4500IMPC has been tested and 
found to comply with specifications for CE marking and standards per 
EMC and Radiocommunications Compliance Labelling (N11785). 

Setup 

Network Wiring 

CAUTION:

 Use only Crestron power supplies for Crestron equipment. 

Failure to do so could cause equipment damage or void the Crestron 
warranty. 

Operations Guide - DOC. 6163 

Interface Module: TPS-4500IMPC  

•

  5