Wall-Mounted Interface Module
Crestron
TPS-4500IMW
Leading Specifications
The table below provides a summary of leading specifications for the
TPS-4500IMW. Dimensions and weight are rounded to the nearest
hundredth unit.
Leading Specifications for the TPS-4500IMW
SPECIFICATION
DETAILS
Video Input Impedance
75 Ohms (with jumper)
100 Ohms (without jumper)
Dimensions
Height: 4.27 in (10.85 cm)
Width: 2.51 in (6.36 cm)
Depth: 1.49 in (3.77 cm)
Weight
0.32 lb (0.14 kg)
As of the date of manufacture, the TPS-4500IMW has been tested and
found to comply with specifications for CE marking.
Setup
Network Wiring
NOTE:
When making wire connections, refer to the latest revision of
the Cresnet Network Interconnect Drawing (Doc. 5411). The document
can be obtained from the Downloads page (CABLES and MANUAL
Libraries) of the Crestron website (www. crestron.com). Search for the
CRESNET.PDF files.
When calculating the wire gauge for a particular network run, the length
of the run and the power factor of each network unit to be connected
must be taken into consideration. If network units are to be daisy-chained
on the run, the load factor of each network unit to be daisy-chained must
be added together to determine the load factor of the entire chain. The
length of the run in feet and the load factor of the run should be used in
the following resistance equation to calculate the value on the right side
of the equation.
4
•
Wall-Mounted Interface Module: TPS-4500IMW
Operations Guide - DOC. 5913
