Crestron
TPSBLOCK-10
10-Position RJ45 Panel Mount Interface
Peel-and-stick NET/VIDEO and RGB labels are supplied with the
TPSBLOCK-10. If desired, a label may be affixed to the surface of the
panel or desktop pop-up/tilt-up device. A matching AUDIO label is also
supplied for use with non-Crestron 8-position RJ45 interface devices.
Industry Compliance
As of the date of manufacture, the TPSBLOCK-10 have been tested and
found to comply with specifications for CE marking and standards per
EMC and Radiocommunications Compliance Labelling (N11785).
Installation
The items required for installation of the TPSBLOCK-10 are appropriate
cutting tools to create the rectangular cut-out area in the panel or desktop
pop-up/tilt-up device, a
0.136-inch
(#29 or approximately 9/64-inch) drill
bit, electric drill and two
#4-40
screws of adequate length with an
appropriate screwdriver. Refer to the following diagrams and perform the
procedure that begins on the next page.
Overhead View
1.408 in
(3.576 cm)
1.210 in
(3.073 cm)
MOUNTING
BRACKETS
10 ft
CABLE
MALE
RJ45 PLUG
0.162 in
(0.412 cm)
Front View
0.687 in
(1.745 cm)
FEMALE RJ45
CONNECTOR & PCB
Pin 1
(Reference Only)
Installation Guide - DOC. 5979A
10-Position RJ45 Panel Mount Interface: TPSBLOCK-10
•
3
