To remove the touch screen after installation, use the included release key
to push down on the security bracket release tabs as shown in the
following illustration while gently pulling the touch screen away from the
mounting bracket.
Connect the Touch Screen
Route all necessary cables through the rear of the mounting bracket, and
then make connections to the side of the touch screen rear housing.
Observe the following when connecting the touch screen:
l
Power and data connection is provided to the touch screen by a single
Ethernet cable. A Crestron PoE (Power over Ethernet) power supply,
such as the PWE-4803RU, or a PoE-capable network switch is
recommended (both not included).
l
The USB ports are used to connect compatible Crestron LED
accessories to the touch screen.
NOTE:
The TSW-770-GV may use either PoE or PoE+ to supply
power to compatible LED accessories over USB; the TSW-1070-GV
must use only PoE+ to supply power to LED accessories over USB.
l
Apply power after all connections have been made.
3
TSW-770-GV and TSW-1070-GV
Quick Start
7 in. and 10.1 in. Wall Mount Touch Screens, Government Version
