DO
GUIDE
DOC. 7659A (2043930) 05.15
Specifications subject to change without notice.
DO
Access the Setup Screens
NOTE:
The TSW-552 can take up to 120 seconds to boot.
When power is applied for the first time, the screen shown in
the following illustration appears.
Tap the
Setup
button to display the TSW-552
Setup
screen.
The setup screens enable basic configuration procedures
prior to regular operation of the TSW-552.
NOTE:
During regular operation of the touch screen, there
are two ways to activate the setup functions:
1. Place a button on the project main page and assign the
reserved join number (17242) that activates setup.
2. Press the hard keys labeled below as 1, 2, 3, and 4 in
sequence twice (press 1, 2, 3, 4, 1, 2, 3, 4) within a 5
second period.
NOTE:
For details on configuring the TSW-552, refer to Doc.
7578 at
.
DO
Learn More
Visit the website for additional information
and the latest firmware updates.
Crestron Electronics
15 Volvo Drive, Rockleigh, NJ 07647
888.CRESTRON | www.crestron.com
As of the date of manufacture, the product has been tested and found to comply with specifications for CE marking.
Federal Communications Commission (FCC) Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions:
(1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Caution:
Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
Industry Canada (IC) Compliance Statement
CAN ICES-3(B)/NMB-3(B)
Crestron product development software is licensed to Crestron dealers and Crestron Service Providers (CSPs) under a limited non-exclusive, non-transferable Software Development Tools
License Agreement. Crestron product operating system software is licensed to Crestron dealers, CSPs, and end-users under a separate End-User License Agreement. Both of these Agreements
can be found on the Crestron website at
www.crestron.com/legal/software_license_agreement
.
The specific patents that cover Crestron products are listed at
.
The product warranty can be found at
.
Crestron and the Crestron logo are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or other countries. Other trademarks, registered trademarks,
and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any proprietary interest in the marks and names
of others. Crestron is not responsible for errors in typography or photography.
This document was written by the Technical Publications department at Crestron.
©2015 Crestron Electronics, Inc.
1
2
3
4
